What is fax csid

If line conditions are particularly bad, there can be several PPR requests on a single partial page before all the frames get through without error.

If this is disabled the fax session will exit with an error after four PPRs. If it is enabled, the fax endpoints will negotiate a slower speed after four PPRs to increase the likelihood of the frames getting through without error. Disable this to prevent a fax session from continually dropping the speed when line conditions deteriorate and, instead, abandon the fax to try again later.

If ECM is off, a received fax page can contain bad lines. This parameter specifies the maximum percentage of bad lines received in a single page before requesting that the page be resent.

After every set of four PPRs the ContinueToCorrect parameter is checked and, if it is on, the modem speed will be reduced and another batch of four PPRs will be allowed. This parameter sets the maximum number of times we can "continue to correct" before terminating the fax. If ContinueToCorrect is disabled, this parameter will have no effect. If line conditions are bad, a page or partial page might be attempted many times before getting through, and this could take a long time.

Set this parameter to a low number to abort such a fax session and try again later. This parameter specifies the maximum percentage of bad lines received in a single page before requesting that the page is resent.

This parameter specifies the maximum number of consecutive bad lines received in a single page before requesting that the page is resent. If this is YES, x resolution is enabled and any low resolution pages will be transcoded to high resolution before being transmitted, thus increasing the amount of data to be sent. If this is OFF, the resolution is restricted to x and any high resolution pages will be transcoded to low resolution, thus reducing the amount of data to be sent and causing the fax to be transmitted more quickly.

This option can also be set to AUTO. AUTO will enable high resolution if any of the pages to be sent are high resolution, otherwise, it will be set to low resolution.

Note that even if a fax sender enables high resolution, the resolution that is negotiated will also depend on the capability of the receiving end. If the receiving end does not support high resolution the fax will be transmitted at the lower resolution even if high resolution is enabled.

If this is YES, x dpi resolution is enabled and any low resolution pages will be transcoded to high resolution before being transmitted, thus increasing the amount of data to be sent.

If this is OFF, the resolution is restricted to x dpi and any high resolution pages will be transcoded to low resolution, thus reducing the amount of data to be sent and causing the fax to be transmitted more quickly. This specifies the maximum page width that the receiver can support.

B4 width faxing is common in Japan. If the sender requests a page width that is bigger than the maximum supported by the receiver, the fax will fail with an error. The data rate to be used for page data transmission. The data rate that can be chosen is limited by the modem that has been negotiated; v17 can go up to , v29 can go up to , v27ter is limited to This email address is being protected from spambots.

You need JavaScript enabled to view it. By clicking submit, you acknowledge Aculab will store and process the personal information provided under legitimate interest. For more information about how we process your data, please see our Privacy policy. Industries Case studies. Automated fax archiving Archive Reporting System Reproducibility. Are you in violation? Billing and Cost recovery Custom reports. Citrix Windows Terminal Services. GoldFax technical: Rendering Fax routers Exchange connector.

GoldFax demos. Into network folders Archive Reporting System. GoldFax Server. In some cases, one would want to set the CSID to another number if you want to have the receiver send responses to another number.

If one has many outbound fax lines, but one wants people to fax back to a specific return fax number, one could set the CSID to the primary inbound line so it appears the fax came from that number. CSID is a string that identifies a sending fax machine. This data is transmitted as part of the fax protocol when the fax transmission is negotiated.